Rubicon Express re1444

Installed some re1444 on the rear. What a difference. If you notice from the picture the rear is a bit higher. The springs in the front are a mix of s10 and yj springs.

Ride is great and when I open the tire carrier the jeep does not lean. They are holding the weight of the jeep and the 35" tire.

From what I can tell there is a 5lbs load difference between these springs and the re1445.

Bayou Jeepers Spring Fling Run

That was my Red XJ there. Miss that Jeep.

Jeep JK-8 Project

Gmail - Inbox - christopher.b.nash@gmail.com:

The guys at Hebert's Town and Country did an great job with this build. It has AEV bumpers front and rear and 35's tires. 

'via Blog this'

Tuffy security console

Picked up a used Tuffy from a friend of mine. I'll update my post with installation info later.

Twister at Barnewell ORV park

Install of air gauge and power point in Jeep Cherokee

This was in my XJ. I took out the cig lighter and replaced it with a air gauge, then I took a cig lighter from a 93 Ford XLT and cut a hole in the lower dash and placed it there. To the right of the rear windshield switch is my in cab winch controle.

ARB Compressor Install

This is where I installed my ARB Compressor. Ran the plugs to the under side of the dash inside. These compressors are relentless and have been tested thoroughly.